Eden WT405 Manuel d'utilisateur télécharger pdf (Page 7)

We recommend you engage these switches at low volumes so that your

sound remains consistent at any volume. At higher volume levels they aren’t

needed but you may want to use them as a matter of taste. Because we

strongly support Freedom of Choice, we’ve incorporated these two switches

into our design. (You’re welcome.)

Master Level Control – Adjusts overall system output and stage loudness.

Headphone Jack – Accepts a standard _ inch stereo or mono headphone

plug. It can also be used as a Master Output send to slave another amplifier.

Output Limit Indicator – Lights to indicate activity of the power amplifier

limiting circuit, which protects the speaker system from severe distortion.

This LED indicates that the amplifier has reached its maximum output level.

Mains On/Off Switch – This switch turns the system power ON or OFF.

The switch illuminates to indicate the presence of AC power present in the

chassis. This switch is prior to the fuse. The switch light can be on even if

the fuse is blown. The light in the switch may flicker depending on local

voltage conditions. This is normal and nothing to be concerned about.

Speaker On/Off Switch – This switch turns off the loudspeaker output

jacks allowing the user to use the headphones only for silent practice. Room

mates and neighbors may really appreciate this feature, especially at three in

the morning.

REAR PANEL FEATURES

Combination Power Cord Jack and Fuse Holder – The removable power

cord is attached here. To access the fuse holder, pull the holder out of the top

of the power receptacle. Your unit was shipped with a spare fuse inserted in

the fuse carrier. USE ONLY THE SAME SIZE AND TYPE FOR

REPLACMENT. Using a fuse with a different rating than specified is a

VERY BAD THING and can cause damage to your amplifier. All

models come with a holder marked (FUSE) and are factory configured for

100/120/ 230/240 only and must be adapted by a service tech for any voltage

change. The standard fuse for U.S. use is a 5 Amp slow blow or time delay

type. Do not use fast blow fuses.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Pas de commentaire

Eden WT405 Manuel d'utilisateur Page 7