Eden HA2000 Spécifications télécharger pdf (Page 12)

The PIR detector is in zone 3, programmed for burglar

mode with an Instant attribute and is named “Hall”.

RemoteControllerHA2000R

The Remote Controller is used to remotely arm or

disarm the system, activate the panic alarm, and put the

system in the "HOME" mode.

z Identifying the parts

1. BUTTON

Pressing this button will put the system into the

Armed mode.

2. BUTTON

Pressing this button for 3 seconds will trigger the

panic alarm regardless of whether the system is

Armed, Disarmed or Home.

3. BUTTON

Pressing this button will put the system into the

Home mode.

PROBLEM? 12

Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to

help you make a perfect installation.

4. BUTTON

Pressing this button will put the system into the

Disarmed mode. If the alarm is sounding,

pressing this button will stop the alarm.

5. TX INDICATOR

6. BATTERY COMPARTMENT

z TX Indicator

When any of these four buttons is pressed, TX

LED will on. Please hold the button until the TX

LED is off to indicate the Remote Controller

has successfully sent out a signal to the Main

Unit.



) On pressing of Panic button, the TX LED

will first flash for three seconds then stay

on to indicate a successful transmission.

z Battery

The Remote Controller uses one “CR2032” 3V

230 mAh Lithium battery as its power source.

Battery life is over 2 years in a normal

domestic environment.

The low battery status will be sent to the

Control Panel along with regular signal

transmission, and, the Control Panel will

display the status accordingly.

z Getting Started

z Remove the battery cover by using a coin to

turn counter-clockwise.

z Insert the battery as shown in diagram, with

unmarked side (negative) of the battery

facing down.

z Replace the battery cover – secure the cover

by using a coin to turn clockwise.

z The Control Panel is already into “Device +/-

“ menu and then select “Add Device” menu.

z Press any buttons on the Remote Controller.

For a Remote Controller, no option needs to be

selected, the Control Panel automatically

assigned it to work in Personal Attack mode.



) “P” for Personal Attack Remote

Controller

Control Panel will give a Personal Attack

alarm when the panic button is pressed

for more than 2 seconds.

StepC5. After the detected Remote Controller is

confirmed, the screen will change to:

E n t e r z o n e N A M E

. . . . . . . . . . . . . + O K

StepC6. You are now invited to give a name or

location description to the device to help

understand system events. You can

enter up to 12 digits as you please for the

name followed by “OK” or just press

“OK “ for no name. Please see section

“Device Naming” for details.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 40 41

Commentaires sur ces manuels

Pas de commentaire

Eden HA2000 Spécifications Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Eden HA2000