
Step 9. Insert the wall plugs if fixing it into plaster
or brick.
Step 10. Screw the base into the wall plugs
Step 11. Screw the cover back onto its base
PROBLEM? 15
Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to
help you make a perfect installation.
z Installation
z Decide on the location of the PIR and if it is
to be corner or surface mounted.
z After the installation site is selected, follow
the steps described above to mount the PIR.
z Press the Test Button to enter Test Mode.
Walk around the protected area noting when
the LED lights up and check that the
detection coverage is adequate.
z When detection coverage is found to be
satisfying, installation is now completed.
III. OpenContactHA2000M
z Mounting Methods
There are two ways to mount the Open Contact, by
either Self-adhesive installation or Screw mounting.
z Self adhesive mounting
Step 1. Clean the surface with a suitable
degreaser.
Step 2. Remove the protective covering from one
side of the double-sided adhesive pad
and firmly apply to the back of the
device.
Step 3. Next remove the other cover and firmly
press the item onto the desired location.
<
<
N
N
O
O
T
T
E
E
>
>
) Do not use the adhesive pad method of
installation on a surface with peeling or
cracked paint, or on a rough surface.
z Screw mounting
The Base has two knockouts, where the plastic is
thinner, for mounting purpose.
To mount the Open Contact
Step 1. Remove the cover
Step 2. Break through the knockouts on the base
Step 3. Using the holes as a template, drill holes
in the surface
Step 4. Insert the wall plugs if fixing into plaster
or brick
Step 5. Screw the base into the wall plugs
Step 6. Screw the cover back on to its base
Door/
Windows
z Installation
Step 1. Ensure the Test/Normal mode jumper
switch is in “ON” position. This is to
Commentaires sur ces manuels