
-press both 4 and 6 to trigger fire alarm
13. A Key
-press both 1 and 3 to trigger panic alarm
14. Mounting Hole
15. Tamper Swtich
16. Numeric Key
PROBLEM? 19
Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to
help you make a perfect installation.
z LED Indicator:
Active LED (Green/Orange):
z Green LED indicates Test Mode.
z Flashing green LED indicates low battery in
Test Mode.
z Orange LED on 5 seconds indicates Normal
Mode.
z Flashing Orange LED for 5 seconds indicates
low battery in Normal Mode.
LED Status (Green/Orange):
z Orange LED indicates Away Mode
z Orange LED flash indicates Home Mode.
z Green LED indicates Disarm Mode.
z Green LED flash indicates failure due to the
following reasons:
¾ No response sent by the control panel
within 4 seconds.
¾ PIN code was incorrect.
¾ Request for “Home” mode during
“Arm” mode.
¾ Request for “Force” arm.
FAULT LED (Orange):
z Orange LED on – Arm Memory
z Orange LED flash – system failure (panel
tamper, AC fault, sensor temper, sensor out
of order, open door)
<
<
N
N
O
O
T
T
E
E
>
>
) When idle, all LED’s are off. After any
key press, the Orange Active LED goes
on for 5 seconds indicating that
HA2000K is active.
) LED 1 turns off after successful
completion of a valid keystroke
sequence, or when the pause in between
key stokes is longer than 5 seconds.
) When the Orange LED turns off before a
valid keystroke sequence is completed,
the previous entered keys are ignored.
) Please press and hold the button until a
short beep is displayed, which confirms
the button pressed is valid.
) Three continuous beeps will sound
indicating the user to repeat the process
again.
z Power:
z HA2000K uses CR2450 3V 540mAH lithium
battery as its power source. Its typical battery
life is over 3 years at an average of 5
activations a day.
z HA2000K can also detect the battery status.
If the battery voltage is low, the Active LED
will flash (Green in Test mode or Orange in
Normal mode) during operation. Low battery
signal will be sent to the Control Panel along
Commentaires sur ces manuels